There are 161 products.
Active filters
Polycarbonate Wing with gold anodize Wing Holder for FANTOM EP 4WD. Improves rear tire grip by installing it, and stability of straight running and cornering at high speed range are also improved.
4 light clear LED light set. Connects to the Rx open slot and includes extention cords for additional light sets.
Designed for 1/10 RWD drift cars. Optional parts for the FAZER D2 drift car. The standard servo horn is made of resin, but upgrading to a CNC-machined aluminum version significantly enhances steering response and holding strength. Additionally, the adjustable design allows fine-tuning of the steering feel by adjusting the arm length from 17mm to 21mm. FAW310 is compatible with Kyosho and Futaba, while FAW311 is compatible with Sanwa and KO.
Ride height adjustment spacers for the Fantom EP 4WD and EXT. Can be installed in the front and rear between the axle mount and chassis. Allows 2 different(0.5mm / 1.0mm) lower positions.
High-precision, high-rigidity CNC machined 6061T6 aluminum servo mount.
CNC machined 2.5mm thick carbon front and rear suspension plate, rear side plate set. Lighter and much stronger than normal aluminum
CNC machined 3mm thick carbon shock stay. The strength is significantly improved compared to the normal FRP product.
Optional parts for the FANTOM EP 4WD. By replacing 6x15x5mm bearing for wheel shaft with 2pcs 6x10x3mm bearings, reduces shaft vibration and friction loss. Gold anodized finish Bearing Holder. 2 sets included.
4 light red LED light set. Connects to the Rx open slot and includes extention cords for additional light sets.
CNC machined 3mm thick carbon shock stay. The strength is significantly improved compared to the normal FRP product
Clamp Type Rear Wheel Hub for the FANTOM EP 4WD. Lightweight gold anodized hub & collar set. Prevents damage to shaft due to core deviation and screws.
A type of LED light unit that takes power from the receiver.
Lineup of 2 lights / 4 lights and clear / red. LED can be added by connecting to the attached connector.
CNC machined 2mm thick carbon upper deck. Achieves increased strength and weight reduction of approximately 5g compared to normal FRP products.
Lightweight Carbon Rear Shaft for the FANTOM EP 4WD. Improves throttle response by lighter rotating parts. The screw part at tip of differential side is assembled with aluminum parts by factory. Recommended to use with EFW003.
■Operating Voltage: 4.8-6.0V
■Size：L35.9mm W15.1mm H28.6mm
■Speed：0.13sec/60°
■Torque：4.5kgf・cm
■Weight：30g
■Led Wire：150mm
■Serration：25 / for FUTABA・KYOSHO
・Servo x1
・Horn A x1
・Horn B x1
・Horn C x1
・3ｘ5ｘ1mm Spacer x1
・Eyeletｘ4
・Screw 2.3x12mm x4
・Screw 2.6ｘ6ｍｍｘ1
・Grommetｘ4
