There are 1300 products.
IF467B Long King Pin Set (MP9)
Long King Pin for MP9 (EP/GP). Essential parts for racing to prevent knuckle arm from dropping during a hard crash. ※Spare/Option parts for MP9 series.
82043 MINI-Z EVO Receiver...
MD201SPB SP Main...
Main chassis for MA-020/VE installed with gold plated terminals for superior conductivity.
OTB248B Non-Decoration Body...
Spare parts for the TURBO OPTIMA.
Optional parts for the OPTIMA and JAVELIN.
OTT244MB Block Tire...
Optional parts for the TURBO OPTIMA.
When use with #OTH245W, it can be used as optional parts for the OPTIMA and JAVELIN.
GPW12B Special Steering Shock
Greatly suppresses vibration and instability of steering control. Increases stability during high speed cornering, acceleration and braking.
OTT244S Block Tire...
Option parts for the TURBO OPTIMA.
Soft compound of 50mm tire. For low grip road surface
MBW015RC Aluminum Front...
74031-14 Back...
Back plate for the KE21 SP / KE25SP / KE25SP2 engine. Back plate elimintes the pull start allowing the use of starter boxes. Less friction allows more performance.
IFW501 Battery Spacer(For...
Optional parts for INFERNO MP10e. Battery spacer for short LiPo batteries.
It is getting popular to use the shorty LiPo batteries to 1/8 EP Buggy due to the improved performance. The battery can be changed the installing position in the battery holder to adjust a center of gravity and balance as well as making weight reduction. That are advantage to use with the shorty LiPo battery. When use the shorty battery to MP10e, it has same effect for car. It can also be used with vintage Scorpion, Beetle and Fazer series.
EFW002 Carbon Gear...
Lightweight Carbon Rear Shaft for the FANTOM EP 4WD. Improves throttle response by lighter rotating parts. The screw part at tip of differential side is assembled with aluminum parts by factory. Recommended to use with EFW003.
MDW303 Setting Tie Rod...
Tie-rod set for the MA-03F/MA-030. Provides four steps of toe angle setup for each narrow and wide configuration.
IFW622 Steel Diff Bevel...
Optional parts for the INFERNO MP9/MP10.
Allows to change the inside center differential gear ratio from 10T/20T to 12T/18T.
By changing the differential effect, improve running stability on bumpy track
Increased a setting variety.
OT251 Aluminum Roll Bar
Spare parts for Javelin. Compatible with the Optima to use the Javelin roll cage body.
MZ605 XSPEED 56 Brushless...
5600KV brushless motor for the MINI-Z sereies.
MZW122BK MINI-Z Pit Mat...
Pit mat with cool MINI-Z logos.
Great for maintanance of your MINI-Z while keeping the pit table clean.
Soft and grippy PVC material avoids small parts to fall off the table.
Size: 24 in. x 17 in. (approx 600 x 430mm).
OTW109 Carbon Rear Shock...
Light weight 2.5mm carbon fiber shock tower. Compared to the stock aluminum shock tower the carbon fiber shock tower is much lighter and with the same durability
OTW105 Carbon Front Side...
Light weight 2.0mm carbon fiber side plates. 5g lighter without compromising the durability.
OTW103 Carbon Rear Plate L...
Light weight 2.5mm carbon fiber plate. Same durability as the stock plates but 5g lighter.
OTH245BK 8 Holes Wheel...
Optional parts for the TURBO OPTIMA.
Color variation of 50mm wheel.
When use with #OTT244M, it can be used as optional parts for the OPTIMA and JAVELIN.
37032B LE MANS 240S...
Turns:15.5T
Operating Voltage:1-3S/12.6V
RPM@7.4V:18870
KV(RPM/V):2550
Max Current:38A
Max Power:320W
Efficiency:90%
Weight(g):179
Motor Diameter(mm):35.8
Motor Length(mm):51.2
Shaft Length(mm):15
Shaft Diameter(mm):3.175
MBW030 Stabilizer Set(for...
3 types of wire diameters can be chosen for both front and rear. Provides a wide range of setting options