There are 1690 products.
Ride height adjustment spacers for the Fantom EP 4WD and EXT. Can be installed in the front and rear between the axle mount and chassis. Allows 2 different(0.5mm / 1.0mm) lower positions.
High-precision, high-rigidity CNC machined 6061T6 aluminum servo mount.
Controls rear pitching to minimize vibration. Delivers strong direct line running as well as cornering. (Includes silicon oil)
* This product is not compatible with the MM2 motor case
CNC machined 3mm thick carbon shock stay. The strength is significantly improved compared to the normal FRP product.
Internal resistance: 0.0011Ω
Continuous maximum current: 60A
Instantaneous maximum current: 80A
Maximum KV value (2S): 13.5T 3200KV
Driving mode: Forward / brake / forward / brake / reverse
Input voltage: 7.2V-11.1V
Compatible motor type: Sensor & Sensorless
BEC output: 6V / 2A
size (mm): 37.5 x 30.8 x 18.7
Weight (g): Approximately 80
Carbon AMB Holder for the MP9/MP10. made from precision high quality carbon material.
Spare Bumper/Body mount set for the USA-1 series. Compatible with the Mad Crusher / FO-XX series.
Carbon Radio plate for the MP10. Carbon allows lighter weight without sacrificing durability.
22 degrees caster angled Aluminum front hub carrier. Compatible with MP10 / MP10 TKI2 / MP10e. Bigger angle increases stability on bumpy tracks.
Newly developed V2 oil damper.
Features:
- Blue anodized cap combined with gunmetal anodized body with laser etched Route 246 logo
- Greatly reduced bounce force with thin rubber diaphragm and thin shock shaft
Spare parts for the MAD CRUSHER / FO-XX. Included Front Housing parts and screws as 1 set. Not compatible with MA002, MA004F and MA331.
Spare parts for the MAD CRUSHER / FO-XX. Updated version of MA004F. Cannot be used with MA002. Must use together with MA353 and MA354.
4 light clear LED light set. Connects to the Rx open slot and includes extention cords for additional light sets.
Optional parts for the INFERNO MP10.
By covering the joint part of the universal swing shaft with an aluminum cap, it has the effect of preventing splashing of grease and improved durability, as well as protecting a damage from dust.
It also protects the pins from falling off in case of damaging the joint parts.
Spare parts for EP&GP versions of the FO-XX 2.0/ Mad Crusher.
CNC machined aluminum center shaft for FZ02 chassis. Durable precision made center shaft for high power motors / high gear ratio setups.
Universal swing shaft for MINI-Z Buggy/Comic Racer. Delivers improved drive efficiency and prevents shaft dropping out. Interchangeable on front and rear.
Aluminum rear shock stay. Provides increased rigidity and better appearance.