There are 1919 products.
Active filters
Unidirectional edge pattern high-grip tires. Realizes exceptional grip, not just on urethane, but also on carpet surfaces.
■MZW38/10 / MZW38-20 / MZW38-30 / MZW38-40
Use for front tires on MINI-Z Racer and MINI-Z AWD. Reduces sticking on urethane surfaces for smooth running characteristics.
LED light unit set equipped with two white LEDs on the front and two red LEDs on the rear.
Compatible with the following models:
- MINI-Z RWD
- MINI-Z FWD
- MINI-Z AWD (with KT-531P transmitter)
- MINI-Z 4x4
- MINI-Z Buggy (with KT-531P transmitter)
- MINI-Z Buggy VE (FHSS)
- MINI-Z Sports series
Option part for the INFERNO MP10, MP10 TKI2, and MP10T.
Lower weight than the existing aluminum clutch shoes, but stronger acceleration with the refined engagement surface.
Two types of clutch springs, Φ0.9 and Φ0.95 are available for a wider range of clutch settings.
Compared to conventional 3pc clutch shoes, durability is greatly improved More accurate for clutch on & off by material change. ※Option parts for INFERNO series.
2 light halogen LED and 2 light red LED light set. Connects to the Rx open slot and includes extention cords for additional light sets.
Spring set for adjusting hardness of rear suspension. Includes 3 different hardness types.■Length：23mm
Realizes more consistent braking due to special material of brake pad and unique glued method between plate and pad.
Optional parts for the INFERNO MP9 Series.
Hard type wheel of existing IFH006 Dish Wheel.
It tends to have a stable running when exiting corner and acceleration.
You can select the wheel depending on racing track and you wish.
Softer front lower suspension arms for the MP10/10e. Forgiving and withstands impacts with the softer material. Suitable for rough tracks.
Setting parts for the INFERNO MP10.
Improved rigidity and strength by adding ribs for front suspension arm.
Option parts for INFERNO MP10T. Harder suspension arm than standard one to improve hardness. Setting parts according to road surface.
Engraved for identification.
Spare parts for MP10
The optimized Ackerman in the MP10 delivers an increase in lock-to-lock steering travel. The design of the new reinforced tie rod ends doesn’t interfere with the inside of the tire and wheel when steering is at maximum angle.
Spare parts for MP10
Increased durability and reliability is achieved with larger φ4.5mm diameter inner hinge pins compared to the φ4.0mm hinge pins on the MP9 TKI4.
Spare parts for MP10
Based on the suspension geometry of the MP9 TKI4 shock stay, the number of shock and upper arm mounting holes has been optimized. In addition, the reinforced rear shock stay delivers increased strength and prevents dirt catching.
